Installation Sheet

1Toilet Installation Instructions

Read entire Toilet Installation Instructions.

Observe all local building and safety codes.

TOOLS AND MATERIALS:

BEFORE INSTALLING

TOILET INSTALLATION INSTRUCTIONS

Level

INSTRUCTIONS

For the following installation instructions for

your new toilet it is assumed that any old

ﬁxtures have been removed and any repairs to

the water supply and/or toilet ﬂange have been

completed.

Unpack and inspect the product for any shipping

damages. If you ﬁnd damages, do not install.

Contact Customer Service at 1-866-855-2284.

If you need assistance or have questions while

installing your toilet, contact Customer Service.

We recommend consulting a professional if you

are unfamiliar with installing bathroom ﬁxtures.

Signature Hardware accepts no liability for any

damage to the ﬂoor, walls, plumbing or for

personal injury during installation.

Shut oﬀ the water supply lines where the new

toilet is being installed.

Latex Caulk

Adjustable Wrench

Hacksaw

Wood Shims

Wax Ring

PAGE 1
TOILET INSTALLATION INSTRUCTIONS BEFORE INSTALLING TOOLS AND MATERIALS: Read entire Toilet Installation Instructions. Observe all local building and safety codes. INSTRUCTIONS Level Hacksaw For the following installation instructions for your new toilet it is assumed that any old ﬁxtures have been removed and any repairs to the water supply and/or toilet ﬂange have been completed. Wood Shims Latex Caulk Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install.
PAGE 2
TOILET INSTALLATION INSTRUCTIONS INSTALLATION 1. Press the new wax ring into place on the toilet ﬂange on the ﬂoor with the ﬂat side down and the tapered edge up. Apply enough pressure to hold the ring in place during installation but be careful not to press it out of shape. 4. Set the toilet down on the ﬂoor and press in place to form a tight seal with the wax ring. Do not move the toilet after placement, this could break the watertight seal and cause leakage. 5.
PAGE 3
TOILET INSTALLATION INSTRUCTIONS 7. Place bolt caps over the anchor bolts on the base of the toilet. 10. Connect the water supply tubes at the bottom of the tank. Turn on the water supply and ﬂush the toilet several times to check for any leaks around the back or base. Tip: If the anchor bolts extend too far over the top of the washers and nuts, use a hacksaw to trim to the correct length. 8.