Installation Sheet

3Toilet Installation Instructions
TOILET INSTALLATION INSTRUCTIONS
7. Place bolt caps over the anchor bolts on the base of
the toilet.
Tip: If the anchor bolts extend too far over the top of the washers and
nuts, use a hacksaw to trim to the correct length.
8. If you are installing a two piece toilet, slide the tank
bolts through the mounting holes on the top of the base
of the toilet. If your toilet has only one piece, move on to
step 9.
9. Thread washers and nuts onto the tank bolts. Verify
that the tank is level and alternately tighten the washers
and
nuts until the tank is resting firmly on the bowl.
10. Connect the water supply tubes at the bottom of the
tank. Turn on the water supply and flush the toilet several
times to check for any leaks around the back or base.
11. Attach the toilet seat.
12. Finish your installation by applying latex caulk or tile
grout around the base of the toilet. This will finish the joint
between your floor and toilet bowl and divert water away
from the base of the toilet.