Installation Guide

SikaBond
®
Construction Adhesive
Flexible Polyurethane
How-To-Use
Materials:
• Safety glasses and gloves
• Standard caulk gun
• Cartridge of SikaBond Construction Adhesive
• Utility knife
• Small spatula
Procedure
1. Make sure that all surfaces are clean, structurally sound, and
dry. Remove all dirt, oil, moisture, and/or old adhesive that may
adversely affect the adhesion of the material.
2. Cut the tip of the nozzle at a 45° angle to the desired bead size,
then puncture the seal inside of the nozzle and place the cartridge
into a caulking gun.
3. Wearing protective gloves and safety goggles, hold the gun at a
45° angle and squeeze the gun handle to start the ow of adhe-
sive. One 10.1  oz. cartridge will yield 24 linear feet of adhesive
in a 1/4” bead.
4. Gun the adhesive onto the substrate/area to be bonded. If desired,
smooth the bead to a desired shape using a spatula.
5. Clean up all tools, spills, and excess material with clean rags after
use. If necessary, use a paint thinner or other approved solvent
such as acetone, following the solvent manufacturer’s precau-
tions.
www.sikausa.com
SKU # 271-407
SKU # 10000-41162