User Manual

IntelliKnight 5808 Installation Manual 151274-L8
7-29
Note: The “SYNC Strbs w/ Sil:” only functions with outputs that use a synchronized output pattern.
5. Press the or arrow to toggle this selection between Y (Yes) or N (No).
6. Press
or ENTER to make your selection and move to the next programming option.
Note: See Section 7.3.1.4 for more information about Synchronization protocol choices.
7.6.5.2 Auto Display Oldest Event
When this feature is programmed Y (Yes) then the oldest un-acknowledge event will automatically display on
the control panel and remote annunciators after there has been no activity on any system touchpad for two
minutes.
7. Press the or arrow to toggle this selection between Y (Yes) or N (No).
8. Press
or ENTER to make your selection and move to the next programming option.
7.6.5.3 Report by Zone or by Point
When the “Report by” option is set to Zone, then the control panel will report events by zone. If Point is selected
then the control panel will report events by point.
9. Press the or arrow to toggle this selection between Zone or Point.
10. Then press
or ENTER. See Section 9 for reporting codes.
7.6.5.4 Plex Door Option
If installing the plex door hardware (PN Plex-2), you must turn the Plex Door option On as described in this
section.
To turn the Plex Door option on/off:
11. Press the or arrow to toggle this selection between Y (Yes) or N (No).
12. Press
or to make your selection and move to the next programming option.
7.6.5.5 Single Key Acknowledge
When this feature is programmed Y (Yes) allows the user to press ACK and display the oldest un-acknowledged
event in the system. Pressing ACK again will acknowledge the event, then display the next oldest un-
acknowledge event without pressing the or arrow.
7.6.6 Daylight Savings
From Daylight Savings, you set the set the start and end week and month of Daylight Saving Time.
To edit Daylight Savings:
1. Enter the installer code.
2. Select 7 for Program Menu.
3. Select 5 for System Options.
4. Select 7 for Daylight Savings.
7.6.6.1 Automatic Daylight Saving Time Adjustment
The control panel has an automatic DST (Daylight Saving Time) adjustment feature. Before January 2007, if this
feature is enabled (set to Yes), the system clock will switch to DST on the first Sunday in April at 2:00 a.m. and