User Manual

IntelliKnight 5808 Installation Manual 151274-L8
8-11
Alarm
A smoke
detector goes
into alarm or a
pull station is
activated.
CO detector
goes into
alarm.
If more than 3
categories are
active at a
single time this
screen will
display.
The dialer seizes control of the phone line
and calls the central station.
The on-board annunciator sounds a loud,
steady beep (any notification devices
attached to the system will also sound).
GENERAL ALARM LED flashes.
The LCD displays a screen similar to this
one.
Press the down arrow to view the alarm. A screen similar
to this one displays.
Press and enter an access code (or activate
the key) to silence the annunciator (and any notification
devices attached to the system).
When the alarm condition clears, press and
enter a code (or activate the key) to restore the panel to
normal.
After sitting idle, events will display in a screen similar to
this:
Note: Alarm and Prealarm are combined into
a single alarm count.
Table 8-1: Operation Mode Behavior
Operation
Mode
Occurs
When
System Behavior In This Mode You Can
SILENCE
RESET