Use and Care Manual

Routine Cleaning
and Maintenance
Due to their low porosity, Silestone® and ECO Line
Colour Series surfaces are highly resistant to
household stains. Cosentino recommends you
use Q-Action* to clean its Silestone® and ECO
Line Colour Series surfaces. If you do not have
this product, the best alternative is to use water
and neutral soap. You should then finish off by
rinsing the surface with plenty of water and
drying it with a soft cloth.
Cleaning
Stubborn Stains
When faced with stubborn stains, here are our
cleaning recommendations:
Grease Stains
Apply Q-Action or VIM® Actifizz® multi-purpose
spray onto the stain and rub it with the soft side of
a sponge until it disappears. Repeat the process if
necessary. Rinse with a generous amount of water
and dry the area.
Limescale
Use cleaning vinegar and a damp sponge. If the
stain persists, you can use a limescale remover
that has been diluted with water. Never leave it on
for more than 2 minutes. Repeat the process if
necessary. Rinse with plenty of water and dry a
soft cloth.
Silicone and Putty Stains
We recommend you remove this type of stain as
soon as possible. To do so, use a knife blade held
horizontally and CleanColorsil, and scrub with a
sponge. If you don’t have any CleanColorsil, you
can use a well-known brand of silicone remover.
Afterwards, rinse with plenty of water and dry.
General
Usage Advice
2
Use & Care Silestone® and Eco Line Colour Series
* Note: for the Canadian market, VIM® Actifizz® multi-purpose spray may also be used.