- Silex Technology Embedded Intelligent Module Developer's Reference Guide

Console Commands
Silex
Page 89
Part Number 140-00192-100
Command
Description
19
00080000
GPIO Trigger4: GPIO4 0 to 1
20
00100000
GPIO Trigger5: GPIO5 0 to 1
21
00200000
GPIO Trigger6: GPIO6 0 to 1
22
00400000
GPIO Trigger7: GPIO7 0 to 1
23
00800000
GPIO Trigger8: GPIO8 0 to 1
24
01000000
GPIO Trigger9: GPIO1 0 to 1
25
02000000
GPIO Trigger10: GPIO2 1 to 0
26
04000000
GPIO Trigger11: GPIO3 1 to 0
27
08000000
GPIO Trigger12: GPIO4 1 to 0
28
10000000
GPIO Trigger13: GPIO5 1 to 0
29
20000000
GPIO Trigger14: GPIO6 1 to 0
30
40000000
GPIO Trigger15: GPIO7 1 to 0
31
80000000
GPIO Trigger16: GPIO8 1 to 0
*Not implemented in early releases of SX-560 firmware.
Power Configuration Commands
Table 41 Power Configuration
Command
Description
SET POWER LEVEL n
Sets the power save mode. High power is for fastest throughput,
low power is for lowest power consumption.
SET POWER <power-level>
Where <power-level> is a numeric value as follows
0 = High Power (processor always on, never sleeps)
2 = Low Power
This is the time in milliseconds to wait before the processor goes
into power save mode. If no I/O occurs on the network or from the
attached peripheral within this time period, the processor will go
into low power mode. The value must be between 0 and 18000000
(30 minutes). A value of 0 disables processor power saving. The
default value is 0.
SH POWER
Shows the current power control mode.