Product specifications

Configuring the Serial Device Server
Silex
Page 19
Part Number 140-00188-180
6. To set the serial port, enter the following commands:
SET PORT S1 SPEED <baudrate> [where <baudrate> is 300 to 921600]
SET PORT S1 PARITY <parity> [where <parity> is ODD, EVEN, MARK, or
SPACE]
SET PORT S1 SIZE <databits> [where <databits> is 7 or 8]
SET PORT S1 FLOW <flowcontrol> [where <flowcontrol> is NONE, XON/XOFF,
CTS, or DSR]
SET PORT S1 MODE <line mode> [where <line mode> is 232, 422, 485, or 485HD;
this command only applies to the SX-510]
The console commands are summarized in Appendix B of this manual.
7. When you have finished entering commands type:
INIT
EXIT
These commands will save the configuration and restart the unit. You are now ready to use the
Serial Device Server.
EXIT
8. Note that you can also access the Internal Command Console in the following ways:
 Internal Web Pages. Use a web browser to connect to the Serial Device Server internal
web pages as described earlier in this chapter. After you have logged in, click Admin on
the left side of the screen, and then click Console. You can now enter console
commands (you must click Enter after each command).
 ExtendView. Select the desired Serial Device Server from the ExtendView main menu.
Click Tools on the menu bar, and then click Telnet Session. Press <ENTER> and then
enter the password access at the # prompt. Press <ENTER> at the Enter Username>
prompt and you are now ready to enter console commands.
IMPORTANT: The console command EXIT must always be used in order to save the changes you made with the
internal command Console.