User`s guide

94
SX-AP-4800AN User's Guide
Factory Default Conguration
1.
Unplug the AC adaptor of SX-AP-4800AN from the outlet.
2.
Press and hold the push switch (SET1) on SX-AP-4800AN while inserting the AC plug
back into the electrical outlet. When the Power LED (Orange) starts to blink, release the
push switch.
How to reset SX-AP-4800AN to factory defaults using the Push Switch:
3.
When Power LED starts blinking in Orange and then turns to Green, the factory default
conguration is completed.
- When receiving power over the Ethernet (PoE), unplug the network cable from the HUB.
Note
- When receiving power over the Ethernet (PoE), press and hold the push switch (SET1) on SX-AP-4800AN
while inserting the network cable back into the HUB.
Note
④
Release
Push Switch
Check
blinking in
Orange
③
②
AC Adaptor
Outlet
Turn on
①
Press and hold
Push Switch