User`s guide

118
SX-AP-4800AN User's Guide
3.
If VLAN is set to ENABLE, the VLAN ID settings will become active.
Congure the VLAN ID appropriate for virtual network you wish to establish according
to the existing network settings you have checked in advance.
When nished, click Submit.
- For details on each conguration item, refer to A. Appendix - A-1. List of All Settings.
- For Native VLAN ID, enter the native VLAN ID of VLAN HUB that you have checked beforehand.
- For VLAN ID of the wireless LAN 1-4, enter VLAN ID of the devices connected to the HUB that you have
checked beforehand.
- After VLAN feature is enabled, you will not be able to configure SX-AP-4800AN via the network with a
dierent VLAN ID from management VLAN ID.
- When VLAN feature is set to ENABLE, the VLAN ID can also be configured from the wireless general
conguration page.
-
Even when VLAN feature is enabled, access from non-VLAN HUB is accepted if the same VLAN ID is set for both
Native VLAN ID and Management VLAN ID. It is recommended to set a same VLAN ID for both of these.
VLAN ID SSID
Wireless LAN1 1 MARKETING
Wireless LAN2 100 GUEST
Wireless LAN3 200 SALES
Sample setting
Note
- For the Management VLAN ID, when VLAN feature is enabled and one of following
authentication modes is set for Network Authentication, enter the same VLAN ID as that of
network group where the RADIUS server is installed.
- 802.1X - WPA-Enterprise - WPA2-Enterprise - WPA/WPA2-Enterprise
TIP