User`s guide

A. Appendix
127
A-1. List of All Settings
A.
Appendix
This chapter explains each conguration item available on SX-AP-4800AN. Some items can
be congured only from the Detail Conguration page. For details, see explanation of each
conguration item below.
Device - Device Conguration
Host Name
General Conguration
*
Detail Conguration
*
Details Set the host name. Be sure to use a unique name that is not used by other devices.
Range Up to 15 characters
Default Value SXxxxxxx (xxxxxx is a last 6-digit of the Ethernet Address)
Device - TCP/IP Conguration
DHCP
General Conguration
*
Detail Conguration
*
Details Enable/Disable the DHCP protocol.
To assign an IP address using DHCP, the DHCP server must be running in your subnetwork.
Range ENABLE/DISABLE
Default Value DISABLE
IP Address
General Conguration
*
Detail Conguration
*
Details Set the IP address.
If the DHCP is enabled on your network, the IP Address obtained from it will be applied.
Range 0.0.0.0 - 255.255.255.255
Default Value The default value can be found on the product label (see the bottom of the unit).
Subnet Mask
General Conguration
*
Detail Conguration
*
Details Set the subnet mask.
If the DHCP is enabled on your network, the Subnet Mask obtained from it will be applied.
Range 0.0.0.0 - 255.255.255.255
Default Value 255.0.0.0
Note When set to "0.0.0.0", a subnet mask appropriate for the IP address is automatically assigned.
Default Gateway
General Conguration
*
Detail Conguration
*
Details Set the gateway address.
If "0.0.0.0" is set, this setting is disabled. When the DHCP is enabled on your network, the Default Gateway
obtained from it will be applied.
Range 0.0.0.0 - 255.255.255.255
Default Value 0.0.0.0