User`s guide

128
SX-AP-4800AN User's Guide
Device - DNS Conguration
DNS Server (Primary)
General Conguration
-
Detail Conguration
*
Details Set a primary DNS server address.
When DHCP is enabled, the DNS server address obtained from it will be given higher priority.
Range
0.0.0.0 - 255.255.255.255
Default Value 0.0.0.0
DNS Server (Secondary)
General Conguration
-
Detail Conguration
*
Details Set a secondary DNS server address.
When DHCP is enabled, the DNS server address obtained from it will be given higher priority.
Range
0.0.0.0 - 255.255.255.255
Default Value 0.0.0.0
Wired LAN Conguration
LAN Interface
General Conguration
-
Detail Conguration
*
Details Congure the physical network type.
Range
AUTO/10Base-T-Half/10Base-T-Full/100Base-TX-Half/10Base-TX-Full/1000Base-T-Full
Default Value AUTO
Note Usually, "AUTO" is used. If a LED on your HUB does not light on when SX-AP-4800AN is powered on,
change the network type to that of the HUB.
Jumbo Frame
General Conguration
-
Detail Conguration
*
Details Enable/Disable Jumbo Frame (ON/OFF).
If enabled, high speed data transmission up to 9696 bytes per frame (excluding FCS 4 bytes) can be
utilized for TCP/IP communication.
Range ON/OFF
Default Value OFF
Note Disable this setting if using SX-AP-4800AN on a 10/100Mbps network.