User`s guide

146
SX-AP-4800AN User's Guide
VLAN Conguration - IEEE 802.1Q VLAN Conguration
VLAN
General Conguration
-
Detail Conguration
*
Details Enable/Disable the VLAN feature.
When set to ENABLE, connect a wired LAN port of SX-AP-4800AN and trunk port of the VLAN HUB via a
network cable.
Range ENABLE/DISABLE
Default Value DISABLE
Note When this setting is enabled, packets of tagged frames are sent to a wired LAN using the wired LAN
port as a trunk port.
Native VLAN ID
General Conguration
-
Detail Conguration
*
Details Set the VLAN ID for native VLAN.
Set the same VLAN ID as a trunk port of the VLAN HUB that will be connected to a wired LAN port of SX-
AP-4800AN.
Range 1-4094
Default Value 1
Note This setting becomes active only when VLAN is set to ENABLE.
The received packets of untagged frames will be processed as native VLAN. For packets with the same
VLAN ID as the native VLAN, tags will not be added.
Wireless LAN 1-4 VLAN ID
General Conguration
-
Detail Conguration
*
Details Set the VLAN ID for each Multi SSID of SX-AP-4800AN.
Range 1-4094
Default Value 1
Note This setting becomes active only when VLAN is set to ENABLE.
The SSID corresponding to each VLAN ID will be displayed on the right.
Management VLAN ID
General Conguration
-
Detail Conguration
*
Details Set the VLAN ID for management VLAN.
When the VLAN is enabled, this will be a VLAN ID to access SX-AP-4800AN. To access SX-AP-4800AN via
wireless LAN, set the same VLAN ID as that of the wireless LAN.
When VLAN feature is enabled and one of following authentication modes is set for Network
Authentication, please enter the same VLAN ID as that of network group where the RADIUS server is
installed.
- 802.1X - WPA-Enterprise - WPA2-Enterprise - WPA/WPA2-Enterprise
Range 1-4094
Default Value 1
Note This setting becomes active only when VLAN is set to ENABLE.
Access to SX-AP-4800AN using IP protocol or FLDP protocol (e.g. Web page, TELNET, Device Server
feature) will be limited to the network groups with the same VLAN ID as the management VLAN ID.
Access from wireless LAN will also be restricted by Access Control feature of SX-AP-4800AN. In order to
access from wireless LAN, set the wireless LAN of the corresponding protocol to ENABLE.