User`s guide

5. Other Features

5-2. Log

Output

To use this feature, the following conditions must be met. If you are using older version of the

software, please install the newest one from our website at http://www.silexamerica.com.

- SX Virtual Link (for Windows) : Ver.3.11.0 or newer

- SX Virtual Link (for Macintosh) : Ver.3.11.2 or newer

- SX-AP-4800AN Firmware : Ver.2.1.0 or newer

- In the following instructions, Internet Explorer 9 and Windows 7 are used as example.

Display may vary depending on the Web browser.

The log can be sent to the Syslog server and saved to the USB storage device at the same time.

- Only one USB storage device can be connected to SX-AP-4800AN to save the log to the USB

storage device. Also, the connected storage device cannot be used over network using SX

Virtual Link.

- When removing the USB storage device from SX-AP-4800AN, please disable the log output

feature beforehand.

TIP

Getting Started

The log information (access log, etc.) can be sent to the Syslog server as well as saved to

the USB storage device connected to SX-AP-4800AN. Once the log le is saved to the USB

storage device, it can be retrieved over a network using SX Virtual link. How to output the

log and retrieve it from the USB storage device is explained.

To retrieve the log information, the USB connection utility, SX Virtual Link is required.

For how to install, refer to 5-1. Device Server Feature. When you send the log to the

Syslog server, please check the IP Address of the Syslog server.

In order to save the log to USB storage

device, prepare a USB storage device such as

USB ash drive, etc. and connect it to SX-AP-

4800AN.