Specifications

About SX-WSG1
2
Status LED
(Orange)
Blinks during data transfer.
3
Link LED
(Green)
<For a wired network connection >
ON A network connection is established through a wired LAN.
Blink
Searching for a network connection
(Blinks when a network cable is disconnected)
< For a wireless connection >
ON
A network connection is established through a wireless LAN
(Infrastructure mode).
Blink
Searching for network connection
(Blinks when the wireless LAN settings on SX-WSG1, such as a WEP
key or SSID, does not match the wireless network)
OFF Running in wireless LAN (Ad hoc mode).
4
Wireless LAN
antenna
This antenna is used for communication through a wireless LAN.
5 Push Switch
This push switch is used to reset to the factory defaults.
For details, refer to Reset to Factory Default.
6 Network Port Connects to the network cable.
7
Status LED
(Orange)
Blinks during data transfer through a wired network.
8
Link LED
(Green)
ON A network connection is established through a wired LAN.
Blink Searching for a network connection.
OFF Running in a wireless LAN.
9 USB Port Connect a USB Cable (A Type connector).
10
Power
Connector
Connect AC adapter.
11
Ethernet
Address
The Ethernet (MAC) Address of SX-WSG1 is found on the bottom.
The last 6 digits are the SX-WSG1's serial number.
Example) If the Ethernet Address is 00:80:92:00:11:22 (noted as 008092001122)
then SX-WSG1's serial number is 001122.
3.Notes on the radio wave
Do not use SX-WSG1 near the following equipment or places.
The following equipment may use the same band. If you use SX-WSG1 near this equipment, the
radio waves from SX-WSG1 and the following devices may interfere with each other.
file:///C|/Documents%20and%20Settings/evillegas.STA/Desktop/a/English/SXWSG1/00_3_about_e.htm (5 of 6) [12/15/2008 10:05:30 AM]