User's Manual

ManualsBrandsSilex Technology ManualsElectronicsWireless 11abg Adapter

SX-10WAG-IT Users Manual

1/4

February 03,2009

SX-10WAG-IT Users Manual

1. Hardware specifications/Compliance.................................................................. 2

2. System Requirements (for the install) ................................................................. 4

3. Setup............................................................................................. 4

Summary of content (4 pages)

PAGE 1
SX-10WAG-IT Users Manual February 03,2009 SX-10WAG-IT Users Manual 1. Hardware specifications/Compliance .................................................................. 2 2. System Requirements (for the install) ................................................................. 4 3. Setup .............................................................................................
PAGE 2
SX-10WAG-IT Users Manual 1. Hardware specifications/Compliance FCC ID：N6C-SX10WAG-IT NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
SX-10WAG-IT Users Manual Operating environment ： Temperature：+0°C to +70°C, +32F to +140F Humidity：20% to 90% Storage environment ： Temperature：-20°C to +80°C, +14F to +158F Humidity：5% to 90% supply voltage ： 3.3V ± 0.3V Host I/F ： miniPCI signal alternative original I/F IEEE802.11b ： Frequency : 2412MHz~2462MHz Transmission system ： DS-SS Transmission speed： 1M/2M/5.5M/11M Automatic detection Channel：1－11ch IEEE802.
PAGE 4
SX-10WAG-IT Users Manual 2. System Requirements (for the install) PC containing: ・32-bit CardBus slot (or Desktop PC with PC Card-PCI adapter) ・miniPCI signal alternative original connector ・32 MB memory or greater ・300 MHz processor or higher When this module is installed in the host product, you must include a "Contain FCC ID : N6C-SX10WAG" in the label of the host product. 3. Setup It uses Driver and a utility of Atheros Communications.