User's Manual

Introduction Silex Page 4
140-00197-100 Revision A
Chapter 2
Hardware Specifications/Compliance
FCC Information
FCC ID: N6C-SXSDCAG
NOTICE
In accordance with FCC Part 15, the SX-SDCAG is listed as a Modular Transmitter device. End products
that include the SX-SDCAG shall have the words “Contains Transmitter module FCC ID: N6C-
SXSDCAG” on an exterior label.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply within the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a different circuit from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help.
The transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
In accordance with 15.407(e), within the 5.15 – 5.25 GHz band, this device must be restricted to indoor
use to reduce any potential for harmful interference to co-channel Mobile Satellite Systems.