User's Manual

eBridge Labeling

Integrator's Guide

Silver Spring Networks

FCC and Government Guidelines

Silver Spring Networks eBridge

FCC ID: OWS-NIC506 IC: 5975A-NIC506

The eBridge is REQUIRED to be professionally installed within the host IED by a properly trained

technician. Improper installation could void the user’s authority to operate the equipment.

Figure 5 – Sample Label for eBridge PCBA

NOTE: For FCC compliance, the following text MUST be included in eBridge manuals and

user’s guides.

User installation is prohibited.

The host meter should be installed so that people will not come within 20 cm (8 in.) of the

antenna.

The antenna of this transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

This equipment has been tested and found to comply with Part 15 of the FCC Rules. This

equipment generates, uses and can radiate radio frequency energy, and if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

disconnected.

• Consult the dealer or an experienced Radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by Silver Spring Networks could

void the user’s authority to operate the equipment.

FCC ID: OWS-NIC506 IC: 5975A-NIC506

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may

not cause harmful interference, and (2) this device must

accept any interference received, including interference that

may cause undesired operation.