User's Manual

eBridge Labeling

Integrator's Guide

Silver Spring Networks

2.1 FCC Guidelines for Devices Containing a Transmitter

Module

The following is an extract from FCC PART 15 UNLICENSED MODULAR TRANSMITTER

APPROVAL, DA 00-1407, Released: June 26, 2000, Section 6 describing labeling

requirements for devices containing a modular transmitter.

Section 6. The modular transmitter must be labeled with its own FCC ID

number, and, if the FCC ID is not visible when the module is installed inside

another device, then the outside of the device into which the module is

installed must also display a label referring to the enclosed module. This

exterior label can use wording such as the following: “Contains Transmitter

Module FCC ID: XYZMODEL1” or “Contains FCC ID: XYZMODEL1.” Any similar

wording that expresses the same meaning may be used. The Grantee may

either provide such a label, an example of which must be included in the

application for equipment authorization, or, must provide adequate

instructions along with the module which explain this requirement.

In the latter case, a copy of these instructions must be included in the application for

equipment authorization."

Figure 6 – Sample Label for IEDs Containing an eBridge

2.2 Safety Information

WARNING!: Severe shock and explosion hazard! Touching energized parts can result in massive

equipment damage, and severe injury or death. Short-circuiting energized parts will result in

blinding flash and explosion. Opening and closing electrical circuits can also produce dangerous

and explosive arc flashes. Involuntary muscular reactions associated with electrical shock may

result in other injuries. Observe the following safety guidelines.

Careful planning of every job is essential. Nothing should be taken for granted. Do not take

chances!

• Read and follow all approved policies and procedures provided by your employer associated

with the procedures in this manual.

• The procedures in this manual must only be performed by qualified workers in accordance

with local utility safety practices, utility requirements, and applicable OSHA and NFPA

standards.

• The information contained in this document is intended to aid qualified personnel, and is

not a replacement for the proper training required to make a person qualified.

• Silver Spring Networks assumes no liability for the customer’s failure to follow these safety

guidelines.

Contains FCC ID: OWS-NIC506, IC: 5975A-NIC506