Installation Instructions

4
STEP 3 (Continued) — Two 3” tabs
3.5
3.6
3.4 If two - 3” tabs are supplied, a plier
stapler should be used to connect
adjacent rolls of insulation.
Note! Caution should be taken not to
staple too close to the base of the
tabs as the staples may pull out
during the sheeting process. This
could result in undesired
appearance and a poor vapor seal.
3.5 At the joined seam, pull the tabs
upward and staple approximately
every 8”. The initial staples should be
placed ½” from the end of the tabs.
3.6 Fold the joined tabs over and staple in
between each original staple,
approximately every 4”. Tuck the
completely sealed tab back into the
joint.
Roofing direction
3.4