Installation Instructions

6”

Eave Strut

5.1 Use double sided tape to attach the insulation roll to the eave strut allowing at least six inches of overhang.

C clamps may need to be used to temporarily maintain this connection until roof sheets are in place.

5.2 Unroll insulation to the other eave of the building allowing similar overhang. Keeping tension on the

insulation.

5.5 Install roof panels. If thermal blocks are supplied they should be installed between the insulation

and roof panels.

Note! It is important to keep the insulation under proper tension as the roof panels are installed. If excess sag

is developed and the top of the insulation is not in contact with the roof sheets condensation can occur.

If there is too much tension overcompression can occur which could diminish thermal performance.

ROOF – STEP 1. Perforating the vapor barrier

Endwall

5.2

Double sided

tape

STEP 5 — Installing insulation

5.1

5.4 Before installing roof

panels carefully trim 6”

of insulation off the

end of the facing and

wrap the facing around

the top of the

fiberglass. This helps

prevent water ‘wicking’

into the building.

Eave Strut

Cut insulation

only NOT facing

6”

5.4