Operation Manual

Assembly

SWW 1500 A1

Slide the upper wall brackets ♦

into the holding ﬁ xtures

on the device's

rear panel and ﬁ rmly screw these, together with the angle bracket

and

the lower wall brackets

, to the rear panel of the device. For this purpose

use the 7 screws M4 x 13 mm (see diagram Wall bracket assembly).

Diagram Wall bracket assembly

Mark two drill holes at a height of 600-650 mm and at a distance of 330 mm. ♦

Mark two more drill holes at a height of 250-300 mm and at a distance of ♦

330 mm. Make sure that the distance between the upper and lower drill

holes is 350 mm (see diagram Drill scheme).

Now with an electric drill and an 8 mm drill bit drill four holes to a depth of, ♦

at least, 40 mm.

330 mm

ø 8 mm, 40 mm

600 mm - 650 mm

350 mm

250 mm - 300 mm

Diagram Drilling scheme

Insert the rawlplugs into the holes and screw in the M4 x 42 screws. ♦

Allow the screw heads to stick out slightly.

Now hang the de

vice on the screws and mark the drill hole for the angle ♦

bracket