Technical data

SilverCrest graphics tablet SGT 10.6 A1
110 - English
Getting started
Proceed as follows to start using your graphics tablet quickly and easily.
Step 1: Inserting batteries into the digital pen
To insert batteries proceed as follows:
1. Remove the cap.
2. Push the cover upwards slightly
and lift it off.
Do not push the cover too far
upwards, as the tabs at the front
could otherwise break off.
3. Remove the film from the sup-
plied battery and insert the bat-
tery. The plus pole (+) must al-
ways point towards the open end
of the pen.
Ensure batteries are always
inserted with the correct polarity.
4. Place the tabs of the cover into
the front of the bottom section
and carefully push down until the
cover snaps into place on the
bottom section. Do not use any
force.
5. Replace the pen cap.