Specifications

07
7. LABELLING
Label marking will be permanent, legible and complied with all agency requirements.
Labels will be affixed to the sides of the power supply showing the following:
6.3 VIBRATION
The subject power supply will withstand the following imposed conditions without
experiencing non-recoverable failure or deviation from specified output characteristics.
6.4 GROUND LEAKAGE CURRENT
The power supply groud leakage current shall be less than 3.5 mA.
6.6 DIELECTRIC STRENGTH
Primary to Frame Ground : 1800 Vac for 1 sec.
Primary to Secondary : 1800Vac for 1 sec.
6.7 INSULATION RESISTANCE
Primary to Frame Ground : 20 Meg.ohms Minimum
Primary to Secondary : 20 Meg.ohms Minimum
- Manufacturer's name and logo.
- Model no., serial no., revision level, location of manufacturer.
- The total power output and the maximum load for each output.
- AC input rating.
7.1 MODEL NUMBER LABEL
Vibration Operating - Sine wave excited, 0.25 G maximum acceleration, 10-250 Hz
swept at one octave / min. Fifteen minute dwell at all resonant points, where resonance
is defined as those exciting frequencies at which the device under test experiences
excursions two times large than non-resonant excursions.
Plane of vibration to be along three mutually perpendicular axes.
6.5 RELIABILITY
The power supply reliability,when calculated by MIL-HDBK-217;latest revision, are
exceed 100,000 hours with all output at maximum load and an ambient temperature
of 25 .