Instructions / Assembly

10
23 23 7/8
74 5/8"
24 3/4
23 23 7/8 24 3/4
HANG VERTICAL PANELS
TIP: Install cam screws in top holes before hanging vertical panels. Be sure to use single and double cam screws
as indicated. See cam shelf instructions.
Hang notched vertical panels from steel rail, leaving as much space between them as your design plans indicate.
WALL
Screwhead
Rail
Broken
Notch
IMPORTANT: If the panel must rest on a screw or bolt head, drill away a small area below the vertical panel notch.

IMPORTANT:
Hang vertical
panel directly on
steel rail, not on
rail cover.
CAUTIONS: Do not install rail cover before hanging vertical panels.
Do not slide or push vertical panel along steel rail.
Do not place vertical panel directly on top of a screw or bolt head. Notch breaks when panel is hung over
screw head.
Mark hole location
with pencil.
Using a 3/8" drill bit, remove
a small amount of material to
accomodate screw head.
Place vertical panel
onto rail.
A correctly hung vertical
panel will be fully seated
and close to the wall.
WALL
Screwhead
Rail
Pencil
Notch
3/8”
Drill bit
Drilled hole to
accomodate
screw head
WALL
WALL
Screw
head
1
3
2