Instructions / Assembly

17
INSTALLING CLEATS
All wall-mounted 72" units with a shelf installed in the bottom holes must be
cleated for additional support. A cleat is 3" high and the width of the bottom
shelf plus ¾". The extra ¾" extends the cleat halfway under each vertical panel.
1. Install unit(s) to be cleated: 
Installation Instructions at the beginning of this manual. Use a level to
ensure the sides are plumb.
2. Attach cleat to wall studs:
the unit. The cleat must be in contact with the bottom of the vertical panels.
Attach cleat to wall studs using rail screws or toggle bolts.
(Steps 3 & 4
3. Pre-drill holes in bottom cam shelf: Drill
3
16" diameter holes near the rear
edge through the bottom cam shelf only.
4. Attach unit to cleat: Attach unit to cleat with 2" screws, driving them
through pilot holes in cam shelf into cleat.