Instructions / Assembly

20
5. SHAKER method for attaching drawer fronts. Pound
   
 
 
6. STANDARD
drawer front screws, attach front to box. Do not fully tighten. Use
hand screwdriver only.
Drawer locations are determined by your design. Follow the guidelines in the nearby
illustration to install the cabinet section of the glides, beginning with the glides for
the bottom drawer.
• Glides for the bottom
drawer are installed
in the 2nd open hole
above the cam shelf.
• Cam shelf above top
drawer is installed one
hole lower than if it
were another set of
glides.
ASSEMBLE DRAWER WITH
SOFT-CLOSE GLIDES
1. Install Euro screw
into front panel
hole.
2. Level or use
square to position
glide on vertical
panel.
3. Use (#6)
5
⁄8"
screw.
Soft-Close,
Full-Extension
Glides
ATTACH SOFT-CLOSE GLIDES TO VERTICAL PANELS
Drawer boxes and drawer fronts are packed separately.
Drawer pulls, glides and screws are found in your

have a separate box of glides.
NOTE: The glides consist of drawer box sections
and cabinet panel sections. Separate them by
pushing the plastic lever and pulling apart.
1. Separate the drawer box section by holding the black
 
2. Locate and align. Align the closed end of the drawer
 
The side of the drawer box includes dimples to help
you align the glide location top to bottom. When the
glide is in the proper installation location, the dimples
will be visible through the holes in the glide.
3. 
5/8" screws on each side. Install a screw through the
glide hole and into the dimple closest to the front of
 
 
near the middle of the box last.
4. Drill for the knob using a 5mm or 3/16" drill bit
through the countersunk hole located on the back
side of the drawer front. Using screw paired with the
knob, attach to drawer front tightly though holes.
1b
1a
Drawer box
section
Unit panel
section
PULL
FORWARD
PUSH
LEVER
4
5a
5b
2
3
6
Space for
5" drawer
Space for
5" drawer
Space for
8" drawer
Space for
12" drawer
Front of
vertical
panel
Attach drawer glide cabinet
panel sections to vertical
panels using Euro screws

5
8" screws.
3 open holes
8 open holes
5 open holes
Vertical Panel
Square
(#6)
5
⁄
8
" screw
Euro screw
1
2
3