Instructions / Assembly
22
BASKETS
TO ATTACH FULL-EXTENSION GLIDES (STEEL):
1. Therststepinattachingyourfull-extensionglidesis
disassembling the glide.
extend the glide. Then press the black plastic tab between
the arrows with your thumb, and pull the smallest section
completely out. (See Figure 1
2. Install smaller glide section onto vertical panel with the
closed end toward wall. The black release tab is towards
the front of the glide section. Set the glide
7
8" back from the
front of the vertical panel and attach the glide using two Euro
screws in the pre-drilled holes.
NOTE: Basket glides are compatible with the pre-drilled holes in
14" vertical panels only. For other depths, you are required
to drill at least the rear mounting holes for the basket
glides in the vertical panels.
3. Hook glide onto basket. Hook the large glide section onto the
basket with the bumper towards the front. (See Figure 2
4. Insert basket. Insert basket section into the installed glides on
the vertical panels.
ADDITIONAL GUIDELINES FOR BASKETS:
Baskets may be installed according to your preferences with
regard to height and spacing. However, we can offer the following
guidelines:
A. If a basket is installed just below a cam shelf, allow at least 2
open holes between the basket glide and the cam shelf.
1. allow at least 10
1
8" or 7 open holes below the center of
glide for an 11" basket
2. allow at least 3 ¾" or 2 open holes below the center of glide
for a 6" basket
C. If a basket is installed directly over another basket,
1. allow at least 9 open holes between glides for an
11" basket
2. allow at least 5 open holes between glides for a 6" basket
Figure 1.
Basket Section Vertical Panel Section
PULL
Press black tab and pull apart.
A.
B.
C.
B.
Figure 2.
2nd Rail
1st Rail
2nd Rail