Instructions / Assembly
24
Our doors are half overlay doors with European hinges.
All doors are pre-drilled to receive our door hinges. We
do not pre-drill for knobs since knob location is based on
personal preference.
ASSEMBLING HINGES & INSTALLING DOORS:
1. Assemble hinges: Assemble hinges using Figure 1.
2. Position door plate onto back of door. Make sure
that the hinge is square to the edge of the door and
not crooked.
3. Use two (#6)
5
⁄8" screws to attach.
4. Position the door. Hold door against unit and position
it so that the top and bottom cam shelves are partly
covered by the door.
5. Attach cabinet plate. Screw the pre-installed hinge
screws on the cabinet plate into the closest pre-drilled
holes at the front of the vertical panel.
6. Adjustinghinges:The hinges can be adjusted slightly
2.
7. Each door hinge comes with a set of metal hinge
covers. The metal hinge covers consist of two pieces
that each snap onto the door plate to conceal the
installation and adjustment hardware.
DOORS
Pivot top section
down and push onto
lever to snap together.
Insert notch
over hinge pin.
Figure 1.
Figure 2.
Door PlateCabinet Plate
Screw B: Moves hinge left to
right along cam shelves.
Screw A: Moves hinge forward
and backwards along vertical
panel.
1
A B
INSTALLING KNOBS:
Determine door knob locations according to your preference, using other cabinetry in your home as a guide. If you
have several knobs to install, consider making a template.
Pre-drill the knob hole(s) from the front side of the door using a 5mm or
3
16" drill bit. We recommend this drilling
direction to avoid the drill bit from chipping out the material on the front side of the door.
TIP: Clamp or hold a scrap board on the back of the door to minimize chip out when the drill bit breaks through.