Instructions / Assembly

FINAL STEPS

RAIL COVER

NOTE: All rail covers are white. The cover is usually concealed

by items stored on the shelves and hanging rods, and it

is paintable.

1. Cut rail cover to length: Using the interior measurements of each

unit, cut the rail cover to length with a hacksaw.

2. Slip cut sections into place: Slip these sections into place over

the rail.

VERY IMPORTANT: Never hang vertical panels on top of the rail

cover. This will cause the notches to crack.

HANGING RODS

1. Install rod end pairs: Install rod end pairs per design. If the design

includes a cam shelf above the hanging rod, leave one open hole

between rod end and cam shelf.

2. Insert pre-cut rods into rod ends: The hanging rods are pre-cut ¼"

less than the shelf width to allow for the thickness of the rod ends.

