Instruction manual

Chapter 9-2 Engine monitoring

For dual engines, the system provides ‘dual bar analog instruments’

to give a precise overview of the rpm synchronization and to make

direct comparison of data between the two engines.

The engine monitoring system provides analog graphical gauges and

digital (numerical readings) data for up to four engines - see display

examples further on in this chapter.

General settings

SimNet will auto detect the engines at start-up and will automati-

cally set up the parameters in default mode. Before using the engine

monitor system, you may want to edit the setup to customize the

read-out. The top line identifies the engine/battery, the default is

ENGINE 1 to 4 or BATTERY 1 to 4. Insert the correct name for the

engine/battery in the Interface setup:

Call up the menu bar, and...

8,3

load the Interface setup

GAIN+

Use the [GAIN+] key to go to the Engine tab

Go to the name you wish to change,

- refer to section 11.5 Alphanumeric names

ENT

Confirm entry and exit

 To change the measuring units, refer to ‘Setup for units’ in section

11.3.