Instruction manual

Chapter 9-8 Engine monitoring

9.4 Second set of engine monitoring displays

The menu points 4, 5 and 6 are a second set of displays, which only

will be visible if the system detected more than two engines on

board.

Call up the menu bar, and...

6,4

load the 2nd Engine status display

- refer to section 9.1.

Call up the menu bar, and...

6,5

load the 2nd Fuel and transmission display

- refer to section 9.2.

Call up the menu bar, and...

6,6

load the 2nd Battery status display

- refer to section 9.3.

9.5 Demo mode

For the purpose of demonstration, the engine function has a demo

mode, which can present static simulated read-outs. To run a demo

of the engine monitoring system:

Call up the menu bar, and...

8,3

load the Interface setup

GAIN+

Use the [GAIN+] key to go to the Engine tab

Go to the bottom line and toggle the demo mode on and off with +/-

ENT

Confirm entry and exit

 Remember to turn off the demo mode again! The monitoring system

will not present any actual readings when the demo mode is running.