Instruction manual

Miscellaneous menu Chapter 10-3
10.2 Loran C
To change the position readouts to Loran C mode, see section 11.2
under Pilot/Position setup, where ‘Display position as’ can be tog-
gled to ‘Loran C’.
MENU
Call up the menu bar, and...
7,2
load Loran C chain display
ADJ
Open for change
+/-
Leaf through the available chains - see listing next page.
If required, go to the slaves, and...
+/-
Toggle between available slaves (not all chains have more than one
slave)
0-9
...and it is possible to alter the figures in the time delay
If required, go to Offset, and key in a positive or negative offset
0-9
Key in a positive or negative offset to the time delay (toggle positive/
negative with +/-)
ENT
Confirm entry