Instruction manual

SETUP menu Chapter 11-17

If not absolutely sure, press [MENU] to exit function without having

made any changes

 Activating ‘Return to all factory presets’ will erase all user-made

settings and restore the basic default settings from the factory. The

unit will restart with ‘Automatic input source setup’ as described in

section 2.5 Initial start-up.

 Activating ‘Return to SimNet/NMEA presets’ will give two choices:

Press [1] Product SimNet reset

Reset this unit only

Will bring this unit only back to factory defaults of the Interface

setup. The unit will restart with ‘Automatic input source setup’ as

described in section 2.5 Initial start-up.

Press [2] Global SimNet reset

Reset entire Simrad group

on the network

Will bring this unit together with all connected units (which are not

turned off at the moment) back to factory defaults of the Interface

setup. The units will restart with ‘Automatic input source setup’ as

described in section 2.5 Initial start-up.

Show test display:

Information in this display is for technicians only.

POWER OFF - RESET

In case, for some reason, the unit is totally locked i.e. no immediate

response from the keypad, then first try to reset the unit by discon-

necting the power supply. Reconnect the power cable and then start

up the unit again by presssing and holding the [PWR] key until a

picture appears on the screen.

MASTER RESET (will return all settings to factory presets)

If the Power off - reset does not solve the problem, you may have to

perform a master reset by disconnecting the power supply, and then

while reconnecting the power cable you will have to press the [PWR]

and [CLR] keys at the same time, and hold both keys depressed until

a picture appears on the screen. All user-made data will be erased,

and all settings are returned to factory presets.