Installation manual

| 11
Wiring | NSO-II Installation Manual
Connecting displays
Upto two displays may be connected to the NSO-II via the HDMI ports.
Currently supported monitors, are the Simrad DI-15, MO-L 15/17/19, MO-16/19/24, legacy
MO-19, and KEPMGB-15T.
It is possible to use third party monitors, however these should conform to the supported
resolution and refresh rates defi ned in “Specifi cations” on page 41.
¼ Note: LCD monitors intended for home/offi ce use are not designed to operate in areas
exposed to direct sunlight, and will appear dark and diffi cult to read. Also, unless carefully
ventilated and protected from moisture, their service life will be greatly compromised in the
marine environment.
Monitors with a HDMI input may be directly connected to. Where monitors have DVI inputs
only, an HDMI-DVI adaptor cable or regular HDMI cable and DVI adaptor plug should be used.
Adaption will not degrade video quality, both formats use a digital signal.
DVI IN
HDMI IN
¼ Note: While the HDMI standard does not state maximum cable length, signal may be com-
promised on very long runs (typically >49 foot), to minimise the chances of this use only high
quality HDMI certifi ed cables. Where length will be close to or exceed this distance, it may be
required to add an HDMI amplifi er or use HDMI-CAT6 adaptors.
Connecting control devices
The NSO-II can be controlled via the OP40 keypad, or by 1 or 2 Touch screens. If a mixed
system is run, with one touch and one non-touch screen, an OP40 will also be required
to control the display without touch. The OP40 can control either screen by pressing the
DISPLAY key.
OP40 control
MARK
VESSEL
STBY
AUTO
PWR
MOB
PLOT GO TO
MENU WIN
1
3
6
7
PQRS
8
TUV
9
WXYZ
MNO
5
JKL
2
ABC DEF
GHI
4
0
STBY
AUTO
OUT
IN
RADARCHART
ECHO NAV
INFO PAGES
DISPLAY
1
3
2
1 OP40 Controller
2 Micro-C drop cable (≤6m (15’))
3 Micro-C backbone for NMEA 2000 data
NSO-II_IM_EN_988-10392-001.indd 11 9/07/2013 3:53:01 p.m.