Installation manual

| 25
Software setup | NSO-II Installation Manual
Wi setup
To connect to a GoFree device a suitable wifi Android tablet or Apple ipad is required.
Navigate to the wifi network connection page on the tablet, and fi nd the ‘GoFree Wifi xxxx’
network. Connect to the network using the eight character password printed on the silver
label of the GoFree module. If the module is installed out of easy access, see the following
section ‘Access Points’ on how to identify the ‘Network Key’ (password) from the NSO-II.
The above dialogue will appear on the NSO-II display when connection is attempted. Select
‘Yes’ for one-time connection, or ‘Always’ if device is to be remembered for regular connection.
Devices
When a wifi device is connected, it should appear in the wifi devices list. Selecting ‘Always
allow’ will mean the device can automatically connect without needing a password each
time. This menu also allows disconnection of devices that no longer require access.
Access Points
This page shows connected GoFree devices and their IP address.
Mode
When more than one device is connected, only one may operate as ‘Primary’. Primary mode
determines that the device is acting as DHCP server - only one DHCP server may exist on a
network at a time.
To set a device as secondary, the NSO-II must initially be connected
to only one GoFree module. Pressing ‘menu’ with the device
highlighted, opens the dialogue that allows setting to secondary.
Once completed, a second module may be plugged in, and will
automatically default to primary.
¼ Note: Use of multiple devices is solely for range extension purposes, and is usually only
required on larger vessels.
NSO-II_IM_EN_988-10392-001.indd 25 9/07/2013 3:54:24 p.m.