Operation Manual

24 |

Navigating with the NSS | NSS Operator Manual

Navigating with the NSS

The navigation function included in the NSS allows you to navigate towards the cursor

position, a waypoint or along a predeﬁ ned route.

For information about positioning waypoints and creating routes, refer “Waypoints, routes &

tracks” on page 22.

The Goto menu

You can start navigation from any panel by using the Goto menu, displayed by pressing and

holding the GO TO / MENU key.

 Note: The Goto cursor option will only be available when the cursor is active on a Chart,

Radar or Echosounder panel.

When the NSS starts navigating, the cross track limits will be indicated

on the chart. See “Navigation settings panel” on page 25.

Navigating on the chart

You can start navigating on the chart from the chart menu and from the Goto menu. The

description and the illustrations below show use of the Goto menu, activated by pressing

and holding the

PAGES key.

Navigate to cursor position

You can start navigating towards a point on the chart by tapping the selected destination,

activating the Goto menu and selecting the cursor option.

Navigate a route

You can start navigating a route by tapping the route and then activating the Goto menu.

When route navigation is started, the Goto menu will expand showing options for skipping a

waypoint, or for restarting the route from current vessel position.

Selecting start point

You can navigate a route, starting from any waypoint, by positioning the cursor over the

selected waypoint and activating the Goto menu.