Operation Manual

Sensors
141
850-165186 / Rev.B
Mounting
Location: Place the sensor where you wish to check the net
condition. This is normally close to the footrope at the center of
the net. If the net is torn, the slack will release one or both of the
sensor’s detection wires.
Rip sensor attachment to the net, location just aft of the footrope. The distance between
the anchor points for the attachment rings and rubber straps must be defined depending
on the size of t he net and how large area you wish to monitor.
(A) = Snap hook and screw link
(B) = Steel attachment rings bent to the net
(C) = Nylon attachment rings bent to the net
(D) = Detection wires
(E) = Rubber strap
(F) = Attachment point