Operation Manual

Simrad PI54
160
850-165186 / Rev.B
Main parts
(A) = Negative charging and fastening lug
(B) = Positive charging and fastening lug
(C) = Communication link
(D) = Location of sensor lamp
(E) = Water switch sensor
(F) = Temperature sensor (label is removed)
Daily operation
Once installed and put to use, the sensor will
automatically be switched on once the
waterswitch is activated. After an initial startup,
the sensor starts transmission of the current
temperature. When the sensor is not in use, check
that the sensor lamp (D) is not flashing from time
to time, as this indicates that the sensor is on and
is discharging its batteries.
You can only operate this sensor with Fast update
rate. The sensor must then be charged
approximately every 30 hours. The optimal
sensor charging temperature is from +10 to
+25°C.
Note that charging sensors at sub-zero temperatures can create
explosive gasses. Simrad AS assumes no liability for the
improper charging of sensors or the use of chargers not specified
in Simrad’s sensor charging documentation.