Operation Manual

Sensor chargers
167
850-165186 / Rev.B
PS30 Charger
Purpose
The PS Charger is a battery charger for secure charging of the
PS and PI sens ors.
Daily operation
1) Attach the charging clamps to the sensor as follows:
Red clamp: Positive fastening lug (+)
Black clamp: Negative f astening lug (-)
2) Ensure that attachment materials, rope etc. does not short
circuit t he charging lugs, preventing charging and causing
damage to the sensor lugs.
3) Observe the sensor’s indiactor lamp. It will flash once every
four seconds during charging.
4) Observe the charge times and temperature limitations:
Normal charge: ~16 hours for full battery capacity.
Charging temperature: To obtain best results, try to keep
the ambient temperature between +10°C and +25°C. The
sensor must not be charged in temperatures above +50°C or
below 0°C!
Warning: Charging a sensor at sub-zero temperature might
develop explosive gases r epresenting a potential
danger. Simrad assumes no liability for improper
charging, o r the use of other chargers than those
approved by Simrad.