Operation Manual

Simrad PI54
180
850-165186 / Rev.B
Echo sounder setup
These settings are used to set up the operational parameters for
the PI54 echo sounder.
To access the dialogue, press the MENU button to access the
main menu. Then, open the Setup menu, and select Echo
sounder setup.
Note that the presentation parameters are defined in a separate
dialogue; the Echo presentation setup dialogue.
MENU Exit
(CD11103D)
Echo sounder setup:
Select transducer:
Transducer 1:
Transducer 1:
TYPE
BEAM ANGLE
DEPTH
02.3 m
PORT
ECHO2Simrad Combi 50&200
12/07
o
Keel depth below surface:
02.6 m
Data on NMEA-out from:
Alarm for fish:
Depth DK alarm min:
Depth DK alarm max:
Velocity of sound in water:
Water profile:
Time scale:
Restart of AUTO pulse/power:
Echo sampling:
Demo mode:
Display:
Depth DS fish:
Transducer installation
Note:
The upper part of the Echosounder setup dialogue is used to
define and set up the echo sounder transducer(s) used on the
PI54. This operation is only carried out once, and that is during
the system installation. DO NOT ADJUST these settings during
normal operation of the echo sounder, as incorrect settings may
result in damage to the PI54 and/or the transducer(s).
For more detailed information on transducer installation, consult
the PI54 installation manual.
Select transducer: Enter the type and main parameters of each
transducer connected to the PI54 system.
Transducer type: Enter transducer type. You can leaf through a
number of predefined transducer types, or define your own.
Note that some of the predefined types are “dual” transducers,
which means t hat both transceiver outputs ports (Echo1 and
Echo2) will be used.