Operation Manual
References
211
850-165186 / Rev.B
Sensor alarms
These settings are used to set up the PI54 parameters related to
sensor alarms.
To access the parameters, press the MENU button to open the
main menu. Then, open the Setup menu, and select Sensor
alarm/calibration .
Each sensor has an individual alarm setting, and you can also
trigger alarms to warn you about sudden temperature changes
and shallow water. Whenever an alarm is triggered an audible
signal is pr ovided, and a message on the display presents the
cause of the alarm. Unless the reason for the alarm is corrected,
or the alarm disabled, it will sound again after 20 seconds.
Due to the amount of choices available for the PI 54, the alarm
parameters are organized in three dialogues.
• Sensor alarm: This dialogue allows you to defined alar ms
related to the inform ation provided by the sensors.
• Surface temperature: This dialogue allows you to set up
alarms to warn you about surface temperatures, and to
indicate sudden temperature changes.
• Clearance: This dialogue allows you to define alarms to
monitor if a trawl or towed object comes too close or too far
off the bottom.
The Sensor alarm/calibration choice on the Setup menu also
allows you to define parameters for depth calibration and offset.
These are explained separately.
Topics
→ Sensor alarms, page 212
→ Surface temperature alarms, page 213
→ Clearance alarm, page 214
Related topics
→ Depth calibration, page 176
→ Offset adjust, page 203
→ Depth alarm setup, page 180
→ Fish alarm setup, page 180