Operation Manual

Simrad PI54

212

850-165186 / Rev.B

Sensor alarms

This dialogue allows you to defi ne alarms related t o the

information provided by the sensors you have in curr ent use on

your PI54 system. The appearance of the dialogue will thus

automatically change to suit your individual configuration.

Sensor alarm

MENU Exit

GAIN- GAIN+

(CD11103W-A)

0010m OFF

0120m OFF

0060m OFF

-0.5°C OFF 10.0°C OFF

0100m ON

LIFT-OFF ON

0350m OFF

0010m ON

Min alarm Max alarm

Height 2:

Depth 3:

Spread 4:

Temp 5:

Bottom sensor alarm:

Catch sensor alarm:

Each sensor has an individual alarm setting. To enable an alarm,

you must define minimum and maximum limits for the sensor,

and set it to ON. If the alarm is triggered, an audible signal will

be provided, and a message will tell you which sensor that

caused the alarm. Once an alarm has been triggered, it is

automatically disabled for 20 seconds. Af ter this time it may be

triggered again unless the alarm situation has been rectified, or

you have disabled the alarm.

The Bottom Contact and Catch sensors can only provide

alarms when they are activated.