Operation Manual

References

213

850-165186 / Rev.B

Surface temperature alarms

This dialogue allows you to define alarms related to the surface

temperature. In order to enable these alarms, your system must

have relevant sensors fitted.

Surface temperature

MENU Exit

GAIN- GAIN+

(CD11103W-B)

00.0°C OFFAlarm minimum:

12.0°C ONAlarm maximum:

02.0°C/min OFF

Shear alarm:

The surface temperature sensor has individual alarm settings for

maximum and minimum temperature. To enable an alarm, you

must define the appropriate limits, and set it to ON. If the alarm

is triggered an audible signal will be provided, and a message

will tell you that the surface temperature alarm was set off.

Once an alarm has been triggered, it is automatically disabled

for 20 seconds. After this time it may be tri ggered again unless

the alarm situation has been rectified, or you have disabled the

alarm. The Shear alarm will be triggered if the temperature

changes faster per minute than the value you have entered.

Alarm maximum/minimum: To enable the temperature

alarms, select upper and lower limits, and then switch On.

Shear alarm: This alarm triggers if the temperature changes

faster per minute than the limit value provided.