Operation Manual

Simrad PI54

216

850-165186 / Rev.B

If you configure less then six sensors, you will be able to set the

Sensor parameter to Dual. You can not use this setting. Dual

sensors are not yet available, and this functionality is not yet

supported by the digital signal processing in the PI54. The

ability to choose Dual is implemented for future expansion only,

and any attempt to choose this setting will not work.

Note: The settings you choose for update rate and communication

channel must be identical to the settings in the relevant sensor. If

these settings are not matched, your PI54 will not be able to

read the information from the sensor!