Operation Manual

Simrad PI54

218

850-165186 / Rev.B

Status setup

These settings are used to set up the PI54 parameters related to

the Status display.

To access the parameters, press the ADJ (Adjust) or ENT

button when you have the Status display in the active window.

Spectrum, display: Use this parameter to select Frequency or

Channel in the left hand graph in the Status display. When

Channel is selected, each comminication channel is shown with

a black bar.

Frequency band: The graph in the Status display is not wide

enough to show all entire frequency band with sufficient

resolution. For this reason, you can select which frequency band

you wish to see. Select any value between 00 and 15. Selecting

00 provides the full bandwidth. Each band (except 00) covers

between 800 and 1000 Hz with some overlap, and the ranges are

shown in the table below.

Band From

(kHz)

Band From

(kHz)

00 43.2 50.4 08 46,3 47,3

01 43,2 44,1 09 46,8 47,7

02 43,7 44,6 10 47,3 48,2

03 44,1 45,0 11 47,7 48,6

04 44,6 45,5 12 48,2 49,1

05 45,0 45,9 13 48,6 49,5

06 45,5 46,3 14 49,1 50,0

07 45,9 46,8 15 49,5 50,4