Operation Manual

Simrad PI54
226
850-165186 / Rev.B
PI CONFIGURATOR
Purpose
The purpose of the PI Configurator utility is to be able to
configure sensors so that they can operate on different
communication channels. Several PI equipped vessels may then
operate simultaneously in the same area without interference.
The utility also allows you to change the update rate on each
sensor. This is the time elapsed between each data transmission
from the sensor to the host PI system.
This document describes software version 3.40.
Introduction
→ Basic information, page 227
→ About sensor configuration, page 229
→ Main dialogue description, page 231
Procedures
→ How to perform software installation, page 234
→ How to interface the sensor, page 235
→ How to perform basic sensor configuration, page 236
→ How to set up a Twin Spread system, page 237
→ How to upload factory settings, page 239
Reference information
→ References, page 240
Maintenance
→ Programming modes, page 262
→ Making a programming cable, page 263
→ Troubleshooting, page 264
Sensor test procedures
→ Sensor test procedures, page 265