Operation Manual

PI Configurator
227
850-165186 / Rev.B
Basic information
Default sensor settings
PI and PS sensors are delivered from Simrad configured with
common default settings. When required, the individual sensors
may be re-configured with regard to:
• Communication channel
• LED control
• Ping control
• Data Update rate
• Remote
• Show channel with LED flash at start up
Who can configure PI sensors?
Sensor configuration is normally performed by authorized
Simrad technicians. However, individuals with basic computer
skills and access to the necessary equipment should not f ind it
difficult.
Programming modes
The PI Configurator configuration software has two
programming modes, Standard and Professional.
Note: It is highly recommended that the configuration of PI and PS
sensors in the Professional mode is only performed by skilled
and experienced personnel.
Necessary equipment
The following hard- and software is required to use the PI
Configurator utility:
• PI Configuration software
• A PC with Microsoft WindowsE 2000 or XP operating
system and a COM port (serial line).
• A sensor programming cable for either a stationary or
portable PC.
The sensor programming cables for stationary and portable
PCs are constructed differently and are not
interchangeable.