Operation Manual

Simrad PI54
234
850-165186 / Rev.B
Software installation
Observe the following procedure to install the PI Configurator
software on a stationary or portable computer. Note that t he
computer must have either Microsoft WindowsE 2000 or
Microsoft WindowsE XP operating system. You must also have
the Winzip utility installed on your computer. if this is not the
case, it can be dowloaded from www.winzip.com.
Note: Certain anti virus applications may cause the installation
process to fail. If you suspect this, close down the anti virus
protection, and reinstall the PI Configurator.
1 Locate the zip file containing the PI Configurator utility.
- The file can be found on a CD, it can be downloaded,
or distributed by e-mail.
2 Copy the zip file to your harddrive, and open it.
-TheWinzip utility is required to open the file.
3 Unpack the installation files to a temporary folder on your
harddrive.
4 Locate and run the setup.exe file.
5 Allow the installation wizard to start. Follow the online
instructions carefully.
Note: If you have a previous version of the PI Configurator utility, the
installation program will remove it. You will then need to restart
the setup.exe file to complete the installation of the new version.
The user guide is available in electronic form on the PI
Configurator CD. It may be viewed by opening the CD’s
contents and double-clicking the file.