Operation Manual

Simrad PI54
236
850-165186 / Rev.B
How to perform basic configuration
Once the sensor is connected to the computer, and you have
established communication, you can use the PI Configurator
utility to change the basic sensor parameters.
1 Click the Read Senor Data button.
- Observe that the current sensor conf iguration
parameters are displayed in the message field. The
information includes sensor type, channel number, and
the sensor’s software version.
2 If required, select a new communication channel in the
spin box next to the Communication channel label.
3 If required, select a different update rate in the spin box
next to the Data update rate label.
4 Press the Configure sensor button to upload the new
parameters.
5 Press Terminate communication, and disconnect the
sensor.